

'12' to indicate that the system is in diagnostic mode Sequence of numbers each number is flashed 3 times before moving on to the The LED in the passenger side ultrasonic sensor will flash the following

Remove the existing bridging link, or unplug the ALDL from its parkingīridge the brown/green cable in ALDL terminal H, to the black cable in The alarm/trouble codes can be read without the use of a 'Tech 1' tool byīridging two terminals in the ALDL connector: Reading Alarm/Trouble Codes Without 'Tech 1' Tool SELECT MODEL: 'NO' to scroll through options The tool, and proceed as follows to check for trouble codes: Insert the alarm specificĬartridge A082M6557 (English language - for others, see service parts list) into Parking socket), and plug in the Tech 1 tool. To diagnose the alarm system, remove the bridging link (or unplug from System ALDL connector located at the inboard end of the passenger sideĮs gibt wohl auch einen Weg den 10-Pol Stecker unter dem rechten Armaturenbrett manuell "zu befragen", sonst eben mit Tech-1: The alarm ALDL is identifiedīy a label on the harness to distinguish it from the engine management/ASS/SIR Module bracket beneath the passenger side fascia.

(which incorporates the bridging link) fixed to the outboard end of the alarm On cars with passenger side S.I.R., the ALDL is parked in a socket The glovebox and is fitted with a bridging link required as part of the selfĭiagnostics. The ALDL is located behind the outboard side of Or remains lit continuously, either the bonnet, tailgate or a door is not fullyĬlosed, or there is a system fault - see below.Īn Assembly Line Diagnostic Link (ALDL) connector socket dedicated to theĪlarm system is provided to enable connection of the Tech 1 scanner tool If the tell tale initially lights only briefly, rather than for 10 seconds, Overridden, blink continuously to indicate that the ultrasonics are activated. Light for approximately ten seconds, and then unless the feature has been If the system is in order, the tell tale will Immediately the alarm is switched on, the system performs a test oil itself,Īnd lights an LED tell tale on the ultrasonic sensor housing at the passenger dann müsste dies hier für deinen Wagen sein (du hast doch noch die Innenraum-Überwachung an den Dachpfosten und nicht wie beim späteren Modell hinten in der Tasche an der Rückwand !?. also hhast Du doch sicher noch nicht dieses *Cobra-Alarm System mit dem rundlichen Handsender drin ?
